In the Console Log window that appears, enter the following command on the bottom to reload the Event Management policies database:Īfter completing the above steps, AUTOREPLY will now respond to the cawtor on sysb. Then in the drop down next to "Action:", select AUTORPLY.Ħ) Click the OK button again in the Message Record window.ħ) Finally, in the main Browser window, select Console Logs in the tree. A new window "Message Record Action - Detail" appears.Įnter 1 for Sequence number. The asterisk is the wildcard for the reply ID of the cawtor.ģ) Click on the diskette icon to save the Message Record, which will now detect the cawtor message sent from the batch job.Ĥ) In the "Message Record - Detail" window, click on the Actions tab. A window titled "Message Record - Detail" will appear. In the right panel, click on the blank paper icon to create a new message record. In the GUI, you will find a tree in the left panel called "Enterprise Management".Ģ) Expand the tree and click "Messages". Do this as per any other SIP extension, but bear this important piece of information in mind: The Cisco 7941 can only deal with 8 character passwords, so keep your SIP authentication secret to 8 characters. Here is a way to set up an AUTOREPLY to cawtor:ġ) Log on to Event Management on the "sysb" mainframe system using the CA NSM Browser Interface. agi.databaseput(family, key, value) > None Adds or updates an entry in the Asterisk database for a given family, key, and value. Now you need to configure the SIP extension in Asterisk. Asterisk cli database put Posted by VoIP Info, on JanuUsage:database put Adds or updates an entry in the Asterisk database for a given family, key, and value.To automatically reply to a cawtor message, an AUTOREPLY message action must be created. If you want to post your AGI code without any database > commands, Ill glance at it. Sub-commands under the command "database" allow a variety of functions to be performed on or with the database.When using the cawtor command, the command will wait for a reply. AGI will auto-answer the channel if something > causes it to do so. i test with Dial and page() but the issue still the same. exten > 506,1,SIPAddHeader(Call-Info: answer-after0) exten > 506,n,Dial(SIP/105) when i call the 506 the SIP/105 still ringing, i have snom 320 and i have set the Auto Answer Indication: on. The functions and applications for Asterisk 11 are linked above, but you should look at the documentation for the version you have deployed. i have asterisk 1.4.43 installed and i want to configure the auto-answer. This is done using a variety of dialplan applications and functions such as: Users can use it to store arbitrary data. Adds or updates an entry in the Asterisk database for a given family, key, and value.PBX-shellCLI> database put family key valore Il comando consente di inserire un record nel DB. Various modules use it for this purpose automatically. Visualizza tutti i record del DB che appartengono a quella famiglia. Asterisk uses it to store information that needs to persist between reloads/restarts.You can read about database migration between those major versions in the section SQLite3 astdb back-end. Asterisk comes with a database that is used internally and made available for Asterisk programmers and administrators to use as they see fit.Īsterisk versions up to 1.8 used the Berkeley DB, and in version 10 the project moved to the SQLite3 database. i have asterisk 1.4.43 installed and i want to configure the auto-answer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |